MycEoLA, End-of-Life Assessment of Mycelium bio-composites in construction
| Dossier | RAAK.MKB19.023 |
|---|---|
| Status | Lopend |
| Subsidie | € 301.598 |
| Startdatum | 1 augustus 2024 |
| Einddatum | 31 juli 2026 |
| Regeling | RAAK-mkb |
| Thema's |
|
In MycEoLA – Mycelium materialen in de bouw end-of-life assessment worden verschillende end of life opties onderzocht van mycelium bio-composiet bouwmaterialen (MBM). Het project wordt uitgevoerd in co-creatie met partners uit het werkveld. Voor afstemming van de resultaten op de marktvereisten en -mogelijkheden wordt een industriële adviesraad gevormd met experts uit de industrie. Het doel is om de toepassing van MBM's als gecertificeerd bouwmateriaal in licentie te geven, zodat architecten en bouwbedrijven er rekening mee kunnen houden in nieuwe ontwerpen; De verwerking aan het einde van de levensduur moet duidelijk en gekwantificeerd zijn.
Eindrapportage
MycEoLA investigated which end-of-life scenarios are suitable for mycelium-bound composites (MBCs) used in construction. These bio-based materials are produced by growing mycelium through fibre-rich residual streams. The project examined not only what can happen to the material after use, but also its functional lifespan, biodegradation, reuse, remanufacturing, biological recovery, energy recovery and the environmental impacts of these routes.
The lifespan tests showed that moisture is the main degradation driver. Under normal indoor conditions, uncoated samples remained stable during the two-year test period. Under prolonged high relative humidity, however, visible fungal contamination appeared within weeks or even days. Protective treatments, particularly Impershield P and the combination with tea tree oil, could delay deterioration but did not replace the need for good moisture management.
Biodegradation strongly depended on the environment. In the aquatic OECD test, the biodegradation threshold was not reached, while clear degradation occurred in soil. Coatings and heat pressing slowed this process. Soil analyses mainly showed changes in microbial activity, without a broad deterioration of the measured toxicity and nutrient indicators.
For remanufacturing, foam-to-foam was the most robust route: at least two cycles were technically feasible. Board-related routes were also possible, but performance declined more rapidly; low recycled fractions showed the greatest potential. Environmental hotspot analysis showed that process energy and a realistic choice of the replaced product strongly affect the final outcome.
The overall conclusion is therefore not one single waste route, but a cascade: first reuse, then remanufacturing, followed by biological recovery and, only use energy recovery methods when it is unavoidable.
Contactinformatie
Consortiumpartners
bij aanvang project- B.V. REWIN West Brabant
- Fairm B.V.
- Fraai Architecten
- HZ University of Applied Sciences
- Impershield Europe B.V.
- Isolco B.V.
- Krown-Design B.V.
- Mogu srl.
- Qbiq B.V.
- REform Gypxel
- Saver N.V.
- Stichting Agrodôme
- V.O.F. Bio-Kultura